Kenmore Appliance Repair Abilene TX

Washer Won’t Drain. Fridge Not Cooling. Dryer Not Heating. Same-Day Service — (325) 331-4829

📞 (325) 331-4829 — Same-Day Available
⚙️ Kenmore error codes diagnosed with tools — not guesses 🔍 Elite, 700 & 800 series specialist ✓ Free to Call 👑 OEM Kenmore Parts 💲 Quote before we touch anything
What We See in Abilene: Kenmore appliances are made by Whirlpool, LG, Electrolux, or Frigidaire depending on the model — which means diagnosis requires knowing which platform your specific Kenmore runs on. Kenmore washers and dryers in Abilene encounter the same hard water (about 14 grains per gallon) and 100°F+ summer heat that strain every appliance. We identify the platform your Kenmore runs on and diagnose it correctly. Many “unfixable” Kenmore appliances have a single part that failed — not a reason to replace.

What Kenmore Problem Brought You Here?

🔆 Kenmore Washer Won’t Drain / F or E Error Codes

Kenmore front-load and top-load washers develop drain pump failures, lid switch faults (top loaders), and control board errors. F21 (drain slow), F5/E2 (door latch), and F20 (no water) are common Kenmore Elite error codes. Abilene’s hard water accelerates pump seal wear. We diagnose the full drain circuit, motor control, and latch before recommending any part. Most Kenmore washer drain repairs run under $245.

🟙 Kenmore Refrigerator Not Cooling

Kenmore side-by-side and French door refrigerators develop evaporator ice blockage from defrost heater or thermostat failure. Inverter board failures (LG-platform Kenmore Elite models) and control board faults cause cooling loss. Abilene’s summer heat stresses sealed systems. We run a full diagnostic — compressor, defrost circuit, fans, control board — before quoting any repair. We quote the actual failed part, not the most expensive guess.

🏱 Kenmore Dryer Not Heating

Kenmore electric dryers most commonly fail at the heating element, thermal fuse, or high-limit thermostat. Gas Kenmore dryers develop igniter and gas valve coil failures. Abilene’s summer heat can cause thermal fuses to blow prematurely when dryer vents are partially clogged. We test the full heating circuit and vent airflow rather than just replacing the fuse. Most Kenmore dryer heating repairs run $90–$260.

❌ Kenmore Dishwasher Not Cleaning / Won’t Drain

Kenmore dishwashers in Abilene accumulate hard water scale on spray arm holes and filters. Control board faults, door latch failures, and drain pump failures are also common. E1/F7E1 and other error codes indicate drain or motor circuit issues. We test water pressure, pump output, spray arm flow, and the control board before recommending any part. Most Kenmore dishwasher repairs run $95–$275.

💥 Kenmore Range / Oven Not Heating

Kenmore electric range bake element failures, oven temperature sensor drift, and igniter switch faults are the most common oven calls in Abilene. Kenmore gas ranges develop igniter failures and gas valve coil faults. We stock most common Kenmore range parts and typically complete oven repairs same day. Call us before buying a replacement.

🔒 Kenmore Washer Lid Switch / Door Latch Failure

Kenmore top-load washers require a working lid switch to spin and agitate. A failed lid switch stops the machine mid-cycle and looks like a control board failure. Kenmore front-load washer door latch failures prevent any cycle from starting. We always test the lid switch or door latch before condemning the control board. Lid switch replacement is $85–$145. Door latch is $95–$165.

Kenmore Appliance Repair Abilene TX: What We Fix

Washers & Dryers

  • Drain pump & motor control board
  • Lid switch (top loader) & door latch (front loader)
  • Washer transmission & agitator dogs
  • Door boot seal & drum bearing
  • Dryer heating element & thermal fuse
  • Gas igniter & valve coils
  • High-limit thermostat & cycling thermostat
  • Dryer motor & idler pulley

Refrigerators, Dishwashers & Ranges

  • Evaporator fan & defrost heater (fridge)
  • Inverter board (LG-platform Elite models)
  • Compressor relay & capacitor
  • Ice maker assembly & water valve
  • Dishwasher control board & door latch
  • Spray arm & filter (hard water scale)
  • Bake & broil element (range)
  • Oven temperature sensor & igniter

Kenmore Repair vs. Replace — Abilene Cost Guide

ProblemTypical Repair CostNew ApplianceVerdict
Washer drain pump$145–$245$600–$1,200✓ Fix it
Washer lid switch / door latch$95–$165$600–$1,200✓ Fix it
Dryer heating element$150–$260$500–$900✓ Fix it
Fridge evap fan & defrost$130–$260$900–$2,500✓ Fix it
Dishwasher control board$195–$340$600–$1,400✓ Fix it
Bake element (range)$110–$195$600–$1,500✓ Fix it
Fridge inverter board (LG platform)$195–$450$900–$2,500✓ Fix it

Estimates for Abilene TX. Exact quote given before any work starts. Parts + labor included.

Why Abilene Kenmore Owners Call Us

OEMGenuine OEM parts for your Kenmore platform whenever possible
$0Surprise charges — quote first, fix second, always
LocalAbilene technician — not a 1-800 call center
Same DayMost Kenmore repairs completed same day in Abilene

Kenmore Appliance Repair Abilene TX FAQ

My Kenmore washer shows F21 and won’t drain. What does that mean?
F21 on a Kenmore Elite front-load washer indicates a slow or blocked drain — the control board detected the drain cycle took too long. Common causes: a clogged coin trap filter (often coins, buttons, or debris), a blocked drain pump impeller, or a worn pump motor. Abilene’s hard water causes mineral buildup in the pump housing over time. We clean the filter, check the drain hose, and test the pump motor before recommending a pump replacement. Most F21 repairs run under $245. We quote which it is after diagnosing — not before.
My Kenmore Elite refrigerator stopped cooling suddenly. Is the compressor bad?
Not necessarily. LG-platform Kenmore Elite refrigerators (most models sold 2010–present with model numbers starting 795) have a known inverter board failure mode that looks like compressor failure. A failed inverter board causes the compressor to stop running entirely — same symptom as a dead compressor, but an inverter board replacement ($195–$450) is far cheaper than a compressor ($350–$700). We test the inverter board, compressor windings, and start relay with proper diagnostic tools before recommending any part. Many Kenmore Elite refrigerators condemned as “compressor failures” had fixable inverter boards.
My Kenmore dryer runs but won’t heat. Do I need a new heating element?
A blown thermal fuse is the most common reason a Kenmore dryer runs but won’t heat — not the element. The thermal fuse is a one-time safety device that blows when the dryer overheats. In Abilene’s summer heat, partially clogged dryer vents cause the dryer to overheat and blow the fuse repeatedly. We test the full heating circuit (element, thermal fuse, high-limit thermostat, cycling thermostat) and check vent airflow before recommending parts. Replacing only the thermal fuse without checking why it blew leads to the same failure in weeks. Most Kenmore dryer heating repairs run $90–$260.
Is a Kenmore appliance worth repairing, or should I just buy a new one?
It depends on which platform your Kenmore was built on. Older Kenmore washers and dryers (pre-2010) built on the Whirlpool Direct Drive or Kenmore 70 platform are extremely durable and worth repairing. Kenmore Elite refrigerators on the LG platform are well-built and worth repairing when the failure is a board or fan — not a sealed system issue. Newer entry-level Kenmore appliances are harder to justify repairing at high cost. We give you an honest assessment after diagnosing: what failed, what it costs to fix, and what a comparable new appliance would cost — so you can decide.

Kenmore Breaking Down in Abilene?

We diagnose first — no surprise charges. OEM parts for your Kenmore platform.

📞 Call (325) 331-4829

Last updated:

📍 1026 N. 1st Street, Abilene, TX 79601
⏰ Mon–Sat 7am–7pm

All Services

Brands We Repair

Service Areas

📞 (325) 331-4829

Free to call · Mon–Sat 7am–7pm

© 2026 Appliance Repair Abilene · 1026 N. 1st Street, Abilene, TX 79601 · All rights reserved.
Samsung, LG, Whirlpool, GE and other brand names are trademarks of their owners. Appliance Repair Abilene is an independent service and is not affiliated with or authorized by any manufacturer.